User's Guide

Accent 800 User’s Guide-Empower 30
4. Grasp the other side of the frame and pull it loose from the device.
Note: When you pull the other side loose, the top or bottom tabs
(steps 5 and 6) may pull out at the same time
5. Pull the tabs on the top of the frame out of the slots on the device.
6. Pull the tab on the bottom of the frame out of the slot on the device.
7. Proceed to the next section, “Attaching the New Frame”.
Attaching the New Frame
You must attach the device frame before you can mount a Keyguard or
TouchGuide over the screen.
1. Press one side of the frame onto the edge of the device.
2. Pull the other side into place.
Note: The top tabs may snap into place as you pull on the side.
3. If necessary, press the top tabs into place.
4. If necessary, pull the bottom tab into place.
5. Look along the inside edge of the frame along the top, bottom, and sides
to make sure the rubber backing didn’t bunch up between the frame and
the edge of the device.
If necessary, lift up the inside edge slightly and press until the
rubber backing fits smoothly between the frame and device.
6. To secure the frame to the device with screws, proceed to the next
section, “Attaching the Frame More Securely”.