User's Guide

Accent 800 User’s Guide-Empower 33
3. While holding the pin in place, lift upward with your fingers to bend
the middle of the Keyguard upward slightly. Then insert the other
pin into the opening on the other side of the device frame.
4. Press down on the bottom portion of the Keyguard to snap the tabs
into place.
Note: If the Keyguard tabs at the bottom do not snap into place,
make sure that the Keyguard is not upside-down. (See step 1.)
Raising the Keyguard
If you need temporary access to the screen—for example, for programming,
changing device settings, cleaning the screen, etc.—you can raise the
Keyguard without removing it completely. If you want to remove the
Keyguard from the device completely, see “Removing the Keyguard” below.
1. While holding the bottom edge of the device with one hand, use the
thumb of your other hand to grasp the bottom edge of the
Keyguard in the middle.
2. Pull upward to release the bottom tabs.
3. Leaving the pins inserted in the top of the
device frame, simply lift the bottom of the
Keyguard to uncover the screen. The
Keyguard will remain the upright position,
giving you easy access to the screen.