User's Guide

Accent 800 User’s Guide-Empower 42
Attaching a QRM Mounting Plate
Your device can be mounted on a table stand or a wheelchair mount. If you
purchased the QRM mounting plate with your device, the plate is already
mounted on the back of your device. If you purchased the QRM mounting
plate separately, or if you need to replace it, follow these instructions.
Important! The mounting plate’s screws are held in place on the plate
with retaining washers. Do not remove the washers.
To attach the QRM mounting plate to the device:
1. Place the device face-down on a flat surface. Be careful not to
scratch the display.
2. Using a Phillips screwdriver, remove the three screws that are
already in the mounting holes.
3. Align the screws in the mounting plate with the threaded holes on
the back of the device.
4. Tighten the screws.
To remove the QRM mounting plate:
1. Loosen the screws just enough that you can pull the plate off the
back of the device.
2. Leave the screws held in place by the washers.
3. Store the plate (with the screws held in place) in a safe location in
case you need to mount it later.