User's Guide

Accent 800 User’s Guide-Empower 43
Mounting a NuPoint Module
Important! The NuPoint module must be securely attached to the
device with all screws to operate properly.
If you purchased a NuPoint module with your device, the module is
already mounted on the device. If you purchased the module later, follow
these instructions to attach it to the device. You can attach the module to
a device with or without a frame.
Note: Your device may look slightly different from the device shown in
these photos.
1. Using a Phillips screwdriver, remove the device handle or port
cover. See “Removing or Reattaching the Handle” on page 24 or
“Attaching the Top Port Cover” on page 25. You will use the screws
you remove from the handle or port cover to fasten the NuPoint
module to the device.
Important! If the device has a frame attached, remove the two top
screws that hold the frame in place. Otherwise, the NuPoint module
will not mount properly. Store these screws in a safe location or
discard them.
Loose screws can be a choking hazard.
2. Align the connector and screw holes on the NuPoint module with
the NuPoint USB connector and screw holes on the top edge of the
back of the device.
3. Slide the module into place, making the sure the connectors are
engaged completely.