User's Guide

Accent 800 User’s Guide-Empower 79
Setting up Automatic Scan Restarts and Rescans
When the auto scan method is selected, your device scans your
vocabulary automatically.
To set the auto scan to restart automatically after a selection and to set
the number of rescans when you make no selection, select Menu >
Toolbox > User Settings > Access Method > Scanning. The Access
Methods window opens to the Configure tab.
Select the Auto scan type and then select Settings.
Note: If you select the Step scan type, these setting are not available.
Automatically Restart Scan Box
Turn this setting on if you want scans to restart automatically after a
selection.
Number of Rescans
Set how many times the scan pattern will repeat if you make no
selection. Select a number between 1 and 5. When an auto scan
reaches the number of rescans you set, the scan will stop until you
activate a switch to start it again. If you don’t want auto scans to
repeat, select 0. Adjust the number of rescans by moving each slider
button until the number you want is displayed or by selecting the +
and – buttons to change the number one digit at a time.