User's Guide

Accent 1400 User’s Guide 42
Mounting the IR Reflector on an Integrated Device
Note: Infrared (IR) functionality is only available on integrated devices. IR is currently supported by
NuVoice software only.
Your device emits infrared signals from the IR area on the back of the device. The optional IR reflector
allows the user to better “aim” those signals from any position. If you have the IR reflector, follow these
instructions to attach it to the device.
The IR reflector can be mounted on the device handle, port cover, or NuPoint module, depending on
which is already attached to your device. The reflector kit includes the reflector, two short screws, and
two long screws.
1. Remove the appropriate screws, as shown.
Handle: If the handle is attached to your device and the front device frame is held in place with
screws, remove the top frame screws.
NuPoint Module: If a NuPoint module is attached to your device, remove the two inside screws
from the module.
Port Cover: If a port cover is attached to your device, and the front device frame is held in place with
screws, remove the top frame screws.
Remove these two screws
Remove these two
screws, if present
Remove these two
screws, if present