User's Guide

Accent 1400 User’s Guide 48
Removing the QRM Mounting Plate
A QRM mounting plate is attached to the back of your device. It allows the device to be mounted on a
table stand or a wheelchair mount. The plate is held in place by four screws.
To remove the QRM mounting plate:
1. Place the device face-down on a flat surface. Be careful not to scratch the display.
2. Remove the screws.
Important: Be sure not to lose the washers that are with the two top screws.
3. Store the plate, screws, and washers in a safe location in case you need to mount the plate later.
To reattach the QRM mounting plate:
1. Place the device face-down on a flat surface. Be careful not to scratch the display.
2. Place the mounting plate over the four holes on the back of the device.
3. Place washers on two of the screws and insert them through the holes at the top of the plate.
4. Insert the remaining two screws through the bottom holes of the plate.
5. Tighten the screws.