Use and Care Manual

Accentua
Vinyl Square Cupola Use and Care
* Your cupola is designed and built for minimal use and care needs.
* Periodically (i.e. bi- annually) check to ensure that fasteners are still secure.
* You will see various changes in coloration of the base and the roof, depending on the environment in which it's located.
* Copper naturally changes from it's original bright color to shades of greens and grays, without copper treatments.
* The white base is UV-protected to prevent fading, but there may be surface adherents that change the hue.
* You may periodically want to clean the cupola base (optional); be careful that your cleaners do not also affect the color
of your structure's roof.
Step 1: Use 2 pieces of wood each ~
24 in. long (2x4s are ideal). Fasten
together with one screw, just loose
enough that boards can still pivot with
pressure.
Step 2: Measure overall length of
roof; find center and mark.
Step 3: Lay your boards over the
peak of the roof, making sure each
board is fully against the surface.
Mark boards with pencil to confirm
angle position. Mark front & back of
roof (not all roofs are symmetrical.)
Step 4: Now working on the ground,
measure to identify center of cupola
base and mark lightly with a pencil.
Step 5: Place louvered midsection
upside down on a smooth flat
surface. Place the flared base section
upside down (widest portion up) on
top of the midsection.
Step 6: Ensure that the base section
is centered on the midsection, and
connect with 1-1/4 in. screws in
each pre-drilled hole.
Step 7: Use pattern to mark cut lines
that match your roof profile. Cut lines
should extend from each lower corner
to your center line drawn in step 4.
Step 8: Cut out roof profile by
starting at corners of cupola base and
cutting to the center. Repeat steps 4 -
6 on the opposite side of your cupola
base. (If your roof is not symmetrical,
make sure that your lines / cuts
match the angles needed for the
front and back roofs.)
Step 9: Position cupola on center of
roof and fasten with 3" white
headed screws. Note: if you want
to utilize venting, cut a hole (app.
8" square) in the roof prior to
fastening cupola. Attach screen
mesh over hole to keep bugs out.)
Congratulations on completing
the installation!
Step 10: Place cupola roof on top of
base. Note: Remove shrink wrap
from copper after Step 9 is done, to
protect copper from oils on skin.
Step 11: Attach roof to base using 1-
3/4 in. white headed screws supplied
with unit.
Note: your cupola may vary in size
from the pictures or include a
different type of midsection (e.g.
have windows or a different number
of slats.) The same installation
practices apply.