User manual

Manual WM-IIRO-8

Command List

I Read all 8 digital bits. xxCR

Ixx Read a single digital bit. (00<=xx<=07) bCR

Oxx0xx Output all 8 digital bits. CR

Ox± Output either high or low on bit x CR

Oxx± Output either high or low on bit xx CR

Ox±xx Output either high or low on bit x for time xx CR

Oxx±xx Output either high or low on bit xx for time xx CR

Y Read digital input COS bit and clear bit Y or N

Txx Set bit 00-07 Mask for COS bit flag, 1=change will set COS CR

Dx± Set digital input active state high or low on bit x CR

Dxx± Set digital input active state high or low on bit xx CR

Cxx Read digital input xx counter (counts each active pulse) xxCR

or Read pulse/free-run output xx counter and reload value xxCR

Rxx Reset digital input counter xx to 0000 CR

Rall Reset all digital input counters to 0000 CR

V Read the Firmware version number x.xxCR

N Resend last response varies

H* Greeting message: copyright, firmware version number varies

BAUD=xxx Set new baud rate. Each x is code number for new baud =:Baud:0x

POD=xx Set pod address to xx varies

PROGRAM= Begin process of uploading custom program to pod special

D Download historical storage of digital input data again varies

FASTDATA Acquire bits 0-7 as fast as possible, then display varies