User manual

Note:
- We cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and assume no
responsibility for any loss of data that may occur when connected to this unit.
- With large amounts of data, it may take longer for the system to read the contents of a USB device.
- Some USB devices may not be properly recognized.
- Even when they are in a supported format, some files may not play or display depending on the content.
(e) Timeshift
When you are playing the program, you can insert the USB, and at any time you can press the [Time shift] button, the
frame will be paused, and you may press the [PLAY] button after a second, it will start to timeshift now. You may press
the PLAY button to return the normal program playing, and the timeshift is continuing, you may see from the below
picture’s bottom which is showing the
time shift status. In this case, you may make the unit to play the recorded program from the start.
Press [Info] key to see time shift information as below:
You can press [fast forward]/[fast back] to move the slide to left or right of the current recording.
Note: Time Shifting will only be available when USB HDD is connected to the system and read/write speed is high enough to do that.
Press [Stop] button to end the timeshift, and it will back to the normal playing of the program
Troubleshooting
Problem Potential Reasons What to do
No picture
Power isn’t connected Connect the power
The power switch is not on Switch on the power
Screen shows’ No Signal’
DVB-T cable not connected Plug in the DVB-T cable
Aerial cable is faulty Check aerial cable and connections
No sound from speaker
No or incorrect connection with audio cable Connect the audio cable correctly
The program is a radio program Press<TV/Radio>key to shift into TV mode
Remote Control is not
responding
The battery is exhausted Change battery
Remote Control is not facing or close enough to the STB Adjust the position of the Remote Control and move closer to the unit
Picture is breaking up The signal is too weak Check aerial cable and connections.
Technical Specifications
Item Sub Item Parameter
Tuner
Input Frequency
174~230MKz
470~860MKz
RF Input level -78~-20dBm
IF Bandwidth 7MHz and 8MHz
Modulation QPSK,16QAM,64QAM
Video
Decoder Format MPEG4 AVC/H.264 HP@L4 MPEG2 [e-mail]
Output Format 576P , 720P, 1080i, 1080p, 4:3 ir 16:9
Output Port HDMI(V1.3C), RGB, CVBS
Audio
Decoder Format MPEG-1 (layer1&2&3 ), WMA, AC3
Audio Output 2xRCA(L/R), COAXIAL
USB2.0
Supported Capacity 500GB
Supported Media MP3,WMA,JPEG,BMP,AVI,MKV
Power
Supply Voltage ~100-240V 50/60Hz
Maximum power
consumption 8W
Standby Power Consumption <0.5W
The manufacturer reserves the right to change the configuration, technical or any other parameters without prior notice.