Installation Sheet

2
4
2
CERTIFICATION: UL WET NO. 20031MG
3
MOUNT FIXTURE TO CROSSBAR
AND INSERT THE BULB
Position the fixture plate over the crossbar.
Align the centre holes of the plate and secure with the
supplied screw knobs.
Insert the bulb. MAXIMUM WATTAGE 60W.
DO NOT EXCEED THE WATTAGE AS STATED
ON THE WARNING LABEL AND IN THE INSTRUCTION
SHEETS
SECURE THE GLASS SHADE AND METAL
FRAME
Position the glass shade and metal frame over the
fixture plate. Align the holes of the plate and
secure with the supplied screws.
* This fixture is wet location rated. In order to ensure
that moisture does not enter the outlet box and cause
a short circuit, clear caulking should be used to seal the
space between the fixture mounting bracket and the
wall. Ensure that a space is left at the bottom to allow
for the escape of moisture. It is recommended that
Indoor/Outdoor Silicon Sealant be used for that purpose**
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that might exceed the
maximum wattage, stated on caution label.
CAUTION
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE