Installation Guide

ManualsBrandsAccess Lighting ManualsOutdoor Wall Lights20350MG-BRZ/CLR

CERTIFICATION: cULus WET NO. 20350

INSTALLATION INSTRUCTIONS

IMPORTANT

Before assembling your ACCESS LIGHTING fixture, please make

sure that you carefully read through this instruction sheet. Save this

instruction sheet and refer to it when additions to or changes in the

fixture configuration are made.

Enregistrer cette feuille d'instructions et de s'y référer lorsque les

ajouts ou changements dans la configuration de montage sont

faites

Consider having your fixture installed by a qualified licensed

electrician.

NOTE: The important safeguards and instructions that appear in

this manual are not meant to cover all possible conditions and

situations that may occur. It must be understood that common sense,

caution and care are factors that can’t be built into any product.

These factors must be supplied by the person(s) caring for and

operating the fixture

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to standard 4” x 2 ½” metal octagon outlet box. The box

must be directly supported by the building structure and U.L

Recognized

STEP-BY-STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off

the Circuit Breaker or by removing the fuse at the fuse box. Just

turning the light off at the light switch is not sufficient to prevent

electrical shock.

APPLICATION

Indoor Wall Spotlight

MODEL NO.

20350

COLLECTION

PREPARE FIXTURE

If there is an existing fixture remove it.

Expose the supply wires from the outlet

box. Screw the supplied crossbar to the

junction box using the supplied screws (1).

Gently pull the supply wires through the

center hole in the crossbar. Slide the fixture

wires through the hole in the back plate.

WHAT WE PROVIDE

 Fixture Housing

 Gasket

 Back Plate

 Crossbar

 Cover

 Mounting Hardware

 1 x GU-10/35W

Bulbs

WHAT YOU NEED

 Screwdriver

 Wire Cutters

 Wiring Supplies as

Specified by the

Electrical Code

Supply Wires from outlet box

Washers

IMPORTANT SAFETY INSTRUCTION

MESURES DE SECURITE A RESPECTURE

Consult a qualified electrician to ensure correct branch

circuit conductor.

Consulter un electricien qualifie pour vous assurer

que les conducteurs de la derivation sont adequats

This product must be installed in accordance with the

applicable installation code by a person familiar with

the contstruction and operation of the product and the

hazards involved.

Ce produit doit etre installe selon le code d’installation

pertinent, par une personne qui connait bien le produit

et son fonctionnement ainsi que les risques inherents

Do not install this fixture in hazardous locations.

N'installez pas cet appareil dans des emplacements

dangereux

Do not install fixture assembly closer than 6 inches from

any curtain or similar combustible material.

Laisser une distance d’au moins 6 pouces entre ce

luminaire et la toute surface combustible.

WARNING: Risk of Fire and Electric Shock

CAUTION: Risque d’ Incendie et de Choc Electriques

Summary of content (2 pages)

PAGE 1
CERTIFICATION: cULus WET NO. 20350 INSTALLATION INSTRUCTIONS COLLECTION IMPORTANT KO APPLICATION MODEL NO. Indoor Wall Spotlight 20350 Before assembling your ACCESS LIGHTING fixture, please make IMPORTANT SAFETY INSTRUCTION sure that you carefully read through this instruction sheet. Save this MESURES DE SECURITE A RESPECTURE Consult a qualified electrician to ensure correct branch circuit conductor.
PAGE 2
CERTIFICATION: cULus WET NO. 20350 CONNECT THE WIRES 2 Connect the black supply wire to the black fixture wire. Secure with the supplied wire nuts. Connect the white supply wires to the fixture wire. Secure with the supplied wire nuts. Either wrap the outlet box grounding (green) wire around the green hexagonal screw provided on the mounting plate or connect it to the supply ground wire provided with the fixture. Secure all wires with U.L Certified electrical tape (not supplied).