Installation Guide

IMPORTANT

Before assembling your access lighting fixture, please make sure that

you carefully read through these instruction sheets. Consider having

your fixture installed by a qualified licensed electrician.

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

PREPARE FIXTURE

If there is an existing fixture remove it.

Expose the supply wire from the J-box.

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box

must be directly supported by the building structure and U.L. Recognized.

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

•

Mounting Hardware

• Crossbar Plate

• Glass Shade

• 2 x 13W GU24

COLLECTION

CERTIFICATION: cUL DAMP

NO. 20451

20451

APPLICATION MODEL NO.

Wall Fixture

VECTOR

PAGE 1
CERTIFICATION: cUL DAMP NO. 20451 INSTALLATION INSTRUCTIONS IMPORTANT Before assembling your access lighting fixture, please make sure that you carefully read through these instruction sheets. Consider having your fixture installed by a qualified licensed electrician. NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur.
PAGE 2
CERTIFICATION: cUL DAMP NO. 20451 2 MOUNT CROSSBAR PLATE Gently pull the supply wires out of the J-box. Mount the crossbar to the J-box with the supplied screws. MAKE WIRE CONNECTIONS 3 Gently pull the supply wires through the hole in the crossbar. Connect the black supply wire to the black fixture wire. Secure with the supplied wire nuts. Connect the white supply wires to the white fixture wire. Secure with the supplied wire nuts.
PAGE 3
CERTIFICATION: cUL DAMP NO. 20451 5 6 7 3 INSERT THE BULBS Insert the supplied bulbs. MAXIMUM WATTAGE 13W. DO NOT EXCEED THE WATTAGE AS STATED ON THE WARNING LABEL AND IN THE INSTRUCTION SHEETS SECURE THE GLASS SHADE AND FRAME Place the glass shade and frame to the plate. Align the hole at the top centre and secure with the supplied screws.