Installation Guide

PREPARE FIXTURE
If there is an existing fixture remove it.
Tighten 3pcs rods x 2 sets to the canopy and fixture.
Insert the fixture wires through the rods to the canopy.
Expose the supply wires from the outlet box.
1
2
4
2
CERTIFICATION: cETLus DAMP NO. 20469LEDD
3
MOUNT THE FIXTURE
Mount the fixture canopy up to the crossbar.
Secure with the supplied screw knob.
MOUNT CROSSBAR AND MAKE WIRE
CONNECTION
Expose the supply wires from the J-box. Install the
crossbar and mount it to the J-Box with the supplied screws.
Gently pull the supply wires through the hole in the
crossbar plate. Connect the black supply wire to
the black fixture wire. Secure with the supplied wire nuts.
Connect the white supply wire to the white fixture wire.
Secure with the supplied wire nuts. Attach the green
J-Box wire around green hexagonal head screw or
connect it to the green supply grounding wire of the
fixture. Secure all wires with electrical tape
(not supplied). Tuck all wires carefully into the J-Box.
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION
VER: 18.12.1