Installation Guide

(1) TOOLS AND MATERIALS REQUIRED
•: • Blade Screwdriver
·: · Sta r Screwdriver
·: · Wire Cutters
·:• Wiring supplies as required by Electrical Code
·:•1 x 100W/A-19 OR 1X18W/GU24
When you replace with the self-ballasted lamp,
the lamp should meet with ul1993 standard.
Attention:
Before assembling your lighting fixture, please read the
following instructions. If you feel you do not have sufficient
electrical experience, refer to a do-it-yourself wiring handbook
or have your fix tur e installed by a qualified licensed electrician.
(2) GENERAL
1 . To ensure the success of the installation, be sure
to read these instructions thoroughly before
beginning.
2. Al l electrical connections must be in accordance with
local codes, ordinances, or the National Electrical
Code. If you are unfamiliar wit h methods of installing
electrical wiring, secure the services of a qualified
licensed electrician.
3. These fixtures are intended for mountin g to a standard
4" x 2 " deep metal octagon J-box. The box
must be directly supporte d by the building
structure and U.L. recognized.
4. Before commencing with the installation,
disconnect the power by turning off the
circuit breaker or by removing the fuse a t the
fuse box . Turning the power off using the light switch
is not sufficient to prevent electrical shock.
NOTE:
The important safeguards and instructions appearing
in this manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense, caution and care, are
factors that cannot be built into any product. The
person(s) c a r i n g for and operating the fixture must
Supply these factors.
(3) UNPACK ING THE FIXTURE
On checking the contents of the box you will find;
1. Fixture assembly
2. Hardware packet
( 4) PREPARING THE FIXTURE
1. If you are replacing an existing fixture, disconnect and remove the old fixture.
Expose the supply wiring from the (1)J-bu.
2. Lay the un-assembled fixture on a soft surface and carefully remove all
the packing material.
3. Cut and trim any excess wire, leaving enough wire for electrical connections.
If you need to adjust the length of the cable , release the (B)cord slr1ln relief first,
then adjust th e cable to th e desired length. Reinstate the (B)cord str1i n relief.
4. Moun t the (4)0-shlped bracket to th e (1)J-box, utilizing the 2 supplied
(5) mounting screws.
5. Connect the BLACK supply wire to the BLACK wire of the fixture with the
supplied (2) wire connectors. Connec t the WHITE supply wire t o the White
wire of the fixture and secure with the supplied (2) wire connectors.
Take green (ground wire) from fixture and green supply wire (ground
supply wire) and attach to ground wire from the(&)green screw located on
the (4)0-shapad br1ckat Use the supplied (2)wire connectors to connect all
three ground wires.
6. Position the (9) canopy over the (4)0-shlped bracket such that the holes
on the sides of the canopy line up with the holes in the crossbar. Secure
the canopy to the crossbar with the supplied th e (7) screws.
7. Remove (11)81111retaining ring, place glass ( no t included) over socket
and secure with glass retaining ring.
8. Insert bulb into socket. DO NOT EXCEED WATTAGE AS PER
CAUTION LABEL.
9. Restore electricity and check the operatio n of your new lighting fixture.
CAUTION:
Ensure that the Fitting is Cool and Switched off, before
Changing the Bulbs.
Do Not use the Bulbs Exceeding Maximum Wattage as Per
caution Label.
Do Not Touch the Bulb while fixture is in operation.
PLEASE SEE DIAGRAM ON REVERSE SIDE OF PAGE.