Instructions / Assembly

CERTIFICATION: cULus DAMP NO. 23780LEDDLP/23781LEDDLP

RESTORE THE ELECTRICITY AND

CHECK THE OPERATION OF YOUR

NEW ACCESS LIGHTING FIXTURE

Please ensure that the fitting is cool and

switched off before replacing the bulb.

DO NOT use bulbs that might exceed the

maximum wattage, stated on caution label.

CAUTION

VER: 23.03.1

PREPARE THE FIXTURE

If there is an existing fixture remove it.

Expose the supply wires from the J-box.

Determine the desired hanging height. Loosen the

set screw in the strain relief located on the canopy.

Gently pull the excess fixture wire into the canopy until

the desired hanging height is reached and re-tighten the

set screw.

MAKE WIRE CONNECTION AND

MOUNT

THE CANOPY

Install the mounting bracket to the J-Box with the supplied

screws. Gently pull the supply wires through the hole in the

mounting bracket. Connect the black supply wire to

the black fixture wire. Secure with the supplied wire nuts.

Connect the white supply wire to the white fixture wire.

Secure with the supplied wire nuts. Attach the green

J-Box wire around green hexagonal head screw or

connect it to the green supply grounding wire of the

fixture. Secure all wires with electrical tape

(not supplied). Tuck all wires carefully into the J-Box.

Align the canopy onto the mounting bracket and secure

with the supplied barrel nuts.

INSERT THE BULB

Insert the bulb.

DO NOT EXCEED THE MAXIMUM WATTAGE AS

STATED ON THE WARNING LABEL