Installation Guide

(1) TOOLS AND MATERIALS REQUIRED
 BLADE SCREW DRIVER
 WIRE CUTTERS
 WIRING SUPPLIES AS REQUIRED BY ELECTRICAL
CODE
 6,8 x 40W/G-9 HGN Bulb
Attention:
Before assembling your lighting fixture, please read the
following instructions. If you feel you do not have sufficient
electrical experience, refer to a do-it-yourself wiring handbook
or have your fixture installed by a qualified licensed electrician.
(2) GENERAL
1. To ensure the success of the installation, be sure to
read these instructions and review the diagrams
thoroughly before beginning.
2. All electrical connections must be in accordance with
local codes, ordinances, or the National Electrical
Code. If you are unfamiliar with methods of installing
electrical wiring, secure the services of a qualified
licensed electrician.
3. These fixtures are intended for mounting to a standard
4” x 2 ¼ ” deep metal octagon outlet box. The box must
be directly supported by the building structure.
4. Before commencing with the installation, disconnect
the power by turning off the circuit breaker or
by removing the fuse at the fuse box. Turning the
power off using the light switch is not sufficient to
prevent electrical shock.
NOTE:
The important safeguards and instructions appearing in this
manual are not meant to cover all possible conditions and
situations that may occur. It must be understood that common
sense, caution and care, are factors that cannot be built into any
product. These factors must be supplied by the person(s) caring
for and operating the fixture.
(3) UNPACKING THE FIXTURE
On checking the contents of the box you will find;
 Back Plate
 Crossbar
 Mounting Hardware
 Body of Fixture
 6,8 x Bulb Covers
 6,8 x Glass Shades
 6,8 x Glass Retaining Rings
Do not install this fixture assembly closer than 6 inches
from any curtain or similar combustible material.
(4) PREPARE THE FIXTURE
Refer to attached illustration of fixture parts and assembly.
1. If you are replacing an existing fixture disconnect and
remove the old fixture. Expose the supply wiring from the
outlet box.
2. Secure the Crossbar to the junction box with the supplied
screws.
3. Pull the Supply wires through the Center Hole in the Back
Plate.
4. Connect the BLACK supply wire to the Black wire of the
fixture with supplied Wire Nuts (2) ensuring a secure
connection.
5. Connect the WHITE supply wire to the White wire from
the fixture a secure with supplied Wire Nuts (2).
6. Attach the ground (GREEN) wire from the fixture to the
outlet box ground terminal (or to the box ground wire).
7. Secure all wire nuts connections with UL listed electrical
tape.
8. Position the Fixture Plate over the Back Plate ensuring
that the holes in the top and bottom of the Fixture Plate
and Back Plate are lined up.
9. Secure Fixture Plate to the Back Plate with the supplied
screws.
10. Slide the Glass Shades over the socket and secure with
the Glass Retaining Rings.
11. Insert the G9/40W HGN bulbs. DO NOT EXCEED
WATTAGE SPECIFIED ON WARNING LABEL
12. Slide the Bulb Covers into place.
13. Restore electricity and check the operation of your new
lighting fixture.
CAUTION:
 Ensure that the Fitting is Cool and Switched off,
Before Changing the Bulb.
 Do Not use Bulbs Exceeding Maximum Wattage, As
Per Caution Label.
 Do Not handle bulbs with bare hands, use supplied
soft cloth.
Warning-Risk of fire and electric shock.
Important safety instructions.
Do not install this fixture in hazardous locations.
***READ & SAVE THESE INSTRUCTIONS ***
ACCESS LIGHTING
MODEL 23907/23908
INSTALLATION & OPERATION INSTRUCTIONS
a c c e s s
L I G H T I N G