Installation Guide

ManualsBrandsAccess Lighting ManualsPendant Lighting28102-BCP/CP

IMPORTANT

Before assembling your ACCESS LIGHTING fixture, please make sure that

you carefully read through these instruction sheets. Consider having

your fixture installed by a qualified licensed electrician.

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

MAKE WIRE CONNECTIONS

Expose the supply wires from the outlet box.

Gently pull the supply wires through the hole in the

crossbar. Connect the black supply wire to the black

fixture wire. Secure with the supplied wire nut.

Connect the white supply wire to the white fixture

wire. Secure with the supplied wire nut. Either

wrap the green wire around one of the protruding screws

or connect it to the supply ground wire. Secure all wires

with electrical tape (not supplied).

Tuck all wires carefully into the J-Box

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box

must be directly supported by the building structure and U.L. Recognized.

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

•

1 x 60W E26 A19 Bulb (28101)

•

1 x 100W E26 A19 Bulb (28102)

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

•

Crossbar

•

Mounting Hardware

•

1 x Glass Shade

COLLECTION

CERTIFICATION: ETL DRY NO. 28101/28102

28101

28102

APPLICATION MODEL NO.

Pendant Fixture GLOW

Summary of content (2 pages)

PAGE 1
CERTIFICATION: ETL DRY NO. 28101/28102 INSTALLATION INSTRUCTIONS IMPORTANT Before assembling your ACCESS LIGHTING fixture, please make sure that you carefully read through these instruction sheets. Consider having your fixture installed by a qualified licensed electrician. NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur.
PAGE 2
CERTIFICATION: ETL DRY NO. 28101/28102 2 3 MOUNT THE CROSSBAR AND CANOPY Mount the crossbar to the J-box with the supplied screws. Hold the canopy up to the crossbar. Align the holes of the canopy and secure with the supplied screw knobs. INSTALL GLASS SHADE AND INSERT THE BULB Hold the glass shade fitting over the socket and secure with the supplied socket knob. Insert the bulb . MAXIMUM WATTAGE 60W / 100W. DO NOT EXCEED THE RECOMMENDED WATTAGE AS STATED ON THE WARNING LABEL AND INSTRUCTION SHEETS.