Installation Guide

PREPARE THE FIXTURE
If there is an existing fixture remove it.
Expose the supply wires from the J-box.
Install the crossbar plate and mount it to the J-Box
with the supplied screws.
1
WHAT YOU NEED
•
Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
2
4
2
CERTIFICATION: cULus DAMP NO. 50011LEDD
3
CONNECT THE WIRES AND MOUNT THE
FIXTURE
Gently pull the supply wires through the hole in the crossbar
and mounting plate and top cover. Connect the black supply
wire to the black fixture wire. Secure with the supplied wire
nuts. Connect the white supply wire to the white fixture wire.
Secure with the supplied wire nuts. Attach the green J-Box
wire around green hexagonal head screw or connect it to
the green supply grounding wire of the fixture. Secure all
wires with electrical tape (not supplied). Tuck all wires
carefully into the J-Box.
Install the top cover to the mounting plate and secure with
the supplied screws.
MOUNT THE FIXTURE
Place the fixture up to the top cover and secure the side
holes with allen screws.
Install the mounting plate and secure with the supplied
thumb screws.
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION
VER: 19.01.1