Installation Guide

IMPORTANT

Before assembling your access lighting fixture, please make sure that

you carefully read through these instruction sheets. Consider having

your fixture installed by a qualified licensed electrician.

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

MOUNT BACK PLATE

If there is an existing fixture remove it. Expose the

supply wires from the j-box. Mount the back

plate to the j-box with the supplied screws.

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box

must be directly supported by the building structure and U.L. Recognized.

WHAT YOU NEED

Screwdriver

Wire Cutters

Wiring Supplies as Specified

by Electrical Code

4 x 60W E26 Medium Base Bulb

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

Crossbar

Mounting Hardware

Mounting Plate

Back Plate

4 x Glass Shade

COLLECTION

CERTIFICATION: CETL DAMP NO. 50178

50178

APPLICATION MODEL NO.

Wall FixtureArchie

PAGE 1
CERTIFICATION: CETL DAMP NO. 50178 INSTALLATION INSTRUCTIONS IMPORTANT Before assembling your access lighting fixture, please make sure that you carefully read through these instruction sheets. Consider having your fixture installed by a qualified licensed electrician. NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur.
PAGE 2
CERTIFICATION: CETL DAMP NO. 50178 CONNECT THE WIRES Gently pull the supply wires. Connect the black supply 2 wire the black fixture wire. Secure with the supplied wire nuts. Connect the white supply wires to the white fixture wire. Secure with the supplied wire nuts. Either wrap the green wire around one of the protruding screws or connect it to the supply ground wire. Secure all wire with electrical tape (not supplied). Tuck all wires carefully into the J-Box.
PAGE 3
CERTIFICATION: CETL DAMP NO. 50177 SECURE THE GLASS SHADES 5 6 3 Secure the glass shades to the fixture, by fitting the glass over the socket. Secure the glass by inserting the supplied screws through the designated hole in the glass and the metal post. Tighten down to secure RESTORE THE ELECTRICITY AND CHECK THE OPERATION OF YOUR NEW ACCESS FIXTURE CAUTION Please ensure that the fitting is cool and switched off before replacing the bulb.