Manualshelf

Installation Guide

ManualsBrandsAccess Lighting ManualsSemi-Flush Mount Lights50481-BS/CFR
12
(1) TOOLS AND MATERIALS REQUIRED
BLADE SCREW DRIVER
WIRE CUTTERS
WIRING SUPPLIES AS REQUIRED BY ELECTRICAL
CODE
Attention:
Before assembling your lighting fixture, please read the
following instructions. If you feel you do not have sufficient
electrical experience, refer to a do-it-yourself wiring handbook
or have your fixture installed by a qualified licensed electrician.
(2) GENERAL
1. To ensure the success of the installation, be sure to
read these instructions and review the diagrams
thoroughly before beginning.
2. All electrical connections must be in accordance with
local codes, ordinances, or the National Electrical
Code. If you are unfamiliar with methods of installing
electrical wiring, secure the services of a qualified
licensed electrician.
3. These fixtures are intended for mounting to a standard
4” x 2 ¼ ” deep metal octagon outlet box. The box must
be directly supported by the building structure and U.L
Recognized.
4. Before commencing with the installation, disconnect
the power by turning off the circuit breaker or
by removing the fuse at the fuse box. Turning the
power off using the light switch is not sufficient to
prevent electrical shock.
NOTE:
The important safeguards and instructions appearing in this
manual are not meant to cover all possible conditions and
situations that may occur. It must be understood that common
sense, caution and care, are factors that cannot be built into any
product. These factors must be supplied by the person(s) caring
for and operating the fixture.
(3) UNPACKING THE FIXTURE
On checking the contents of the box you will find;
Mounting Hardware
Fixture Assembly
Glass Diffuser
1 x 150W/HGN/120V/J78mm Bulb
(4) PREPARE THE FIXTURE
Refer to attached illustration of fixture parts and assembly.
1. If you are replacing an existing fixture disconnect and
remove the old fixture. Expose the supply wiring from the
outlet box.
2. Assemble the suspension Rods(1) and secure to Fixture
canopy with supplied Washers & Nuts(2).
3. Attach the Crossbar to the junction box with the supplied
Mounting Screws (3).
4. Attach the Supply Wires to the Fixture Wires:
The Black supply wire attaches to the Black fixture
wire and the White supply wire attaches to the
White fixture wire.
5. Attach the Green/Ground wire from the fixture to the
Electrical Supply Wire or to the Green Screw located on
the Mounting Plate. Secure these connections with
supplied Wire Nuts (4) and tape these connections with
electrical tape.
6. Position the Threaded Rod through the center of the
Fixture Canopy. Secure with the Brass nut (5).
7. Insert the 1 x 150W/HGN/120V/J78mm Bulb (6).
DO NOT EXCEED WATTAGE SPECIFIED ON WARNING LABEL
8. Place the Bulb cover (7) onto the Socket.
9. Position the glass Diffuser (8) and secure it to the
fixture plate with the supplied Knobs(9) .
10. Restore electricity and check the operation of your new
lighting fixture.
CAUTION:
Ensure that the Fitting is Cool and Switched off,
Before Changing the Bulb.
Do Not use Bulbs Exceeding Maximum Wattage, As
Per Caution Label.
Do not Handle the Bulbs with Bare hands. Use a soft
Cloth.
Do not place fixture on or near combustible material.
***READ & SAVE THESE INSTRUCTIONS ***
ACCESS LIGHTING
MODEL 50481
INSTALLATION & OPERATION INSTRUCTIONS
a c c e s s
LIG H T I N G

Summary of content (2 pages)