Installation Sheet

MOUNT THE BACK PLATE
If there is an existing fixture remove it. Expose the supply
wires from the J-box. Install the crossbar plate and mount
it to the J-Box with the supplied screws.
Gently pull the supply wires through the center hole in the
crossbar and then through the center hole in the back
plate.
Position the back plate over the crossbar allowing the two
screws protruding from the crossbar to pass through the
designated holes in the back plate. Secure with the
supplied washers.
1
WHAT YOU NEED
•
Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
2
4
2
CERTIFICATION: cULus DRY NO. 50564
3
CONNECT THE WIRES
Connect the black supply wire to the black fixture
wire. Secure with the supplied wire nuts. Connect the white
supply wire to the white fixture wire. Secure with the supplied
wire nuts. Attach the green J-Box wire around green
hexagonal head screw or connect it to the green supply
grounding wire of the fixture. Secure all wires with electrical
tape (not supplied). Tuck all wires carefully into the J-Box.
Position the fixture with the sockets over the clip centered on
the back plate ensuring that the holes at the top and bottom
of the clip align with the holes in the fixture plate. Secure
the fixture with the supplied screws.
INSERT THE BULBS
Insert the bulbs. MAXIMUM WATTAGE 40W.
DO NOT EXCEED THE MAXIMUM WATTAGE AS
STATED ON THE WARNING LABEL AND
INSTRUCTION SHEET.
SECURE THE GLASS SHADE
Fit the glass shades over the sockets. Secure by screwing
into the threaded metal portion of the socket.
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that exceed the
maximum wattage, stated on caution label.
CAUTION
Ver:17.12.1