Installation Sheet

1
2
4
2
CERTIFICATION: cULus DRY NO. 52043/52043LEDDLP
3
PREPARE THE FIXTURE
If there is an existing fixture remove it.
Adjust to the required length and secure with the
supplied hex nut.
WIRE CONNECTIONS AND MOUNT THE
FIXTURE
Expose the supply wire from the J-box. Mount the straight
bar to the J-box with the supplied screws. Connect the
black supply wire to the black fixture wire. Secure with
the supplied wire nuts. Connect the white supply wire to
the white fixture wire. Secure with the supplied wire nuts.
Attach the green J-Box wire around green hexagonal head
screw or connect it to the green supply grounding wire of
the fixture. Secure all wire with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
Position the fixture up to the crossbar. Align the centre hole
of the canopy and secure with the supplied screw knob.
INSERT THE BULBS
Clip supplied decorative lamp rings onto the lamp.
Insert the bulbs.
DO NOT EXCEED THE MAXIMUM WATTAGE AS
STATED ON THE WARNING LABEL.
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that might exceed the
maximum wattage, stated on caution label.
CAUTION
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
VER: 18.11.1