Instructions / Assembly

1
2
4
2
CERTIFICATION: cULus DRY NO. 64065LEDDLP/64066LEDDLP
3
PREPARE FIXTURE
If there is an existing fixture remove it.
Determine the desired hanging height. Carefully pass the
fixture supply wires through fabric shade center hole to
each extension rods and secure the rods to the canopy.
MAKE WIRE CONNECTIONS AND MOUNT
THE FIXTURE
Expose the supply wires from the J-box and pass the
wires through the center hole on the mounting bracket.
Secure the mounting bracket to the J-box with the
supplied screws.
Connect the black supply wire to the
black fixture wire. Secure with the supplied wire nuts.
Connect the white supply wire to the white fixture wire.
Secure with the supplied wire nuts.
Attach the green J-Box
wire around green hexagonal head screw or connect it to
the green supply grounding wire of the fixture.
Secure all
wires with U.L. Certified electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
Align the fixture canopy onto the mounting bracket and
secure with suppled screws.
INSERT THE BULBS AND MOUNT THE
GLASS PLATE
Insert the bulbs.
DO NOT EXCEED THE MAXIMUM WATTAGE AS
STATED ON THE WARNING LABEL.
Secure the supplied center rod and align the glass plate
onto the center rod. Secure with supplied plastic washer,
metal washer and hex-nut followed by the decorative cover
and barrel nut.
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that might exceed the
maximum wattage, stated on caution label.
CAUTION
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
VER: 21.04.1