Installation Guide
IMPORTANT
Before installing your Access Lighting Inteled system, please make
sure that you carefully read through these instruction sheets.
The Inteled LED system is designed to be installed as a DIY plug
and play project with the appropriate accessories, however if
the system is to be hard-wired and electrical work is involved the
system requires installation by a qualied licensed electrician.
GENERAL INFORMATION
NOTE: The important safeguards and instructions that appear
in this Manual are not meant to cover all possible conditions and
situations that may occur. It must be understood that common sense,
caution and care, are factors that can’t be built into any product.
These factors must be supplied by the person(s) caring for and
operating the xture. The Inteled system is fully dimmable with most
universal dimmers, however it is recommended that LV electronic
dimmers are utilized to ensure full system compatibility and
efciency. Non-dimmable installations should not exceed 48ft and
dimmable circuits not to exceed 24ft.
With its simple plug and play connections and built-in drivers,
the Inteled system can be used in a variety applications and
is important that the project be pre-measured and the correct
components and suitable electrical connections are determined
before proceeding with the installation.
OPTIONAL INTELED COMPONENTS
780LED 12” Module
781LED 22.75” Module
782LED 39.5” Module
783LED 47” Module
784PWB Electrical Box with On/Off Switch
785PWC, 786PWC 3ft and 6ft Power Cords and Plugs
787CON 11” Flex Connector
789SPC 6ft Power Cord with In-Line On/Off Switch.
CA
INSTALLATION INSTRUCTIONS
780/1/2/3LED MODULES
Certied for
use with Inteled
module system
SUPPLIED
• LED Module
• 2 x Spring Steel Clips
• 2 x Mounting Screws
• 788CON (butt connector)
• Spliced Wire Connector
REQUIRED
• Marking pencil.
• Phillips Screwdriver
• Small Blade Screwdriver
• Wire Cutters
• Optional Inteled Components
• Wiring Supplies as Specied
by Electrical Code
LED Module and optional Power Cords
786/786PWC or 789SPC
LED Modules interconnected with supplied
Butt connector
LED Modules interconnected with optional
787CON Flex connector
LED Modules can be connected to either
end of the optional 784PWB power box
Optional 784PWB switch box can be connected on
both ends for placement anywhere within the circuit
Customizeable mounting options
Building Blocks of Light
120v Modular LED system