Instructions / Assembly

IMPORTANT
Before assembling your access lighting fixture, please make sure that
you carefully read through these instruction sheets. Consider having
your fixture installed by a qualified licensed electrician.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations
that may occur. It must be understood that common sense, caution and
care, are factors that can’t be built into any product. These factors must
be supplied by the person(s) caring for and operating the fixture.
STEP BY STEP INSTRUCTIONS
Before starting your installation disconnect the Power by turning off the
Circuit Breaker or by removing the fuse at the fuse box. Just turning the
light off at the light switch is not sufficient to prevent electrical shock.
MAKE WIRE CONNECTION WITH
TRANSFORMER
If there is an existing fixture remove it.
Connect the black supply wire to the black transformer
input wire. Secure with the supplied wire nuts.
Connect the white supply wires to the white transformer
input wire. Secure with the supplied wire nuts.
Either wrap the green wire around one of
the protruding screws or connect it to the supply ground
Secure all wire with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
1
GENERAL INFORMATION
All electrical connections must be in accordance with all ordinances,
Local and National Electrical Codes. These fixtures are intended for
mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box
must be directly supported by the building structure and U.L. Recognized.
WHAT YOU NEED
• Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
INSTALLATION INSTRUCTIONS
WHAT WE PROVIDE
• Mounting Hardware
• Fixture Assembly
COLLECTION
1
CERTIFICATION: CETL DAMP NO. 87105UJ
87105UJ
APPLICATION MODEL NO.
Pendant fixture