Specifications

PARAMETER REFERENCE MANUAL26
OSCILLATORS
¦ Key Follow
As in oscillator1.
¦ Balance
Mirrors the Balance parameter in the oscillator1 page.
¦ Detune
0 to 127: Fine-tunes oscillator2 upwards. Modulation destination “Osc2 Detune“.
¦ FiltEnv>Pitch
As in Classic mode.
¦ Sync Frequency
0 to 127: Adjust the frequency of the internal sync oscillator.
Modulation destination “Osc2 FM Amount”.
Oscillator2(WaveTable)
¦ Mode
Classic, HyperSaw, WaveTable etc.: Selects the basic type of oscillator.
¦ Index
1 to 127: This determines the playback position within the currently selected Wavetable. Each of the 128
available values represents either a particular wave or the interpolation of the two nearest waves. Modulating
the Index of a wavetable with an LFO or Envelope will often result in a highly-dynamic variation in the timbre
of a sound, impossible via any other means.
¦ Table
Sine ... Domina7rix: Selects one of many wavetables.
¦ Interpolation
Use this parameter to determine how smoothly the different waves are blended you sweep the index param-
eter.
¦ FM Amount
0 to 127: The intensity of frequency modulation. Modulation destination “Osc2 FM Amount“.
¦ FiltEnv>Pitch
>-64 to +63: How much the lter envelope modulates the pitch of oscillator2. This was implemented in pre-
vious Virus models to facilitate sync sweeps, and has been retained for compatibility reasons.
Modulation destination “FiltEnv>Osc2 Pitch“.
¦ Sync
Off, On: Activates/deactivates oscillator synchronization. Whenever oscillator1 starts a new cycle, oscilla-
tor2 resets its phase).
¦ FiltEnv>FM
-64 to +63: Controls how much lter envelope is applied to FM Amount. This was implemented in previous
Virus models to facilitate FM sweeps, and has been retained for compatibility reasons.
Modulation destination “FiltEnv>FM Amt“.
Oscillator2(HyperSaw)
¦ Mode
Classic, HyperSaw, WaveTable etc.: Selects the basic type of oscillator.
¦ Density
1.0 to 9.0: The number of sawtooth waves used. The volumes are cross-faded for completely smooth tran-
sitions. Modulation destination “Osc2 Shape“.
¦ Spread
0 to 127: Nominal detuning between individual waves in the HyperSaw. Modulation destination “Osc2
PulseWidth“.
¦ Semitone
As in oscillator1. Modulation destination “Osc2 Pitch“.