Specifications

PARAMETER REFERENCE MANUAL36
OSCILLATORS
Sub Oscillator
An extra “slave” oscillator tuned an octave below its master oscillator. If oscillator1 is in Classic mode, the
sub-oscillator is a Square or Triangle wave slaved to oscillator1. If either oscillator1 or 2 is in HyperSaw
mode, the sub oscillator is HyperSub instead
¦ Volume
0 to 127: Sub oscillator mix. In HyperSaw mode, this parameter crossfades between HyperSaw and Hyper-
Sub.
Modulation destination “SubOscVolume“.
¦ Shape
Square, Triangle: Selects the sub oscillator waveform.
Not available if oscillator1 is in HyperSaw or WaveTable mode.
Noise
¦ Volume
Off, 1 to 127: The level of noise. If set to Off, the Color parameter will not be visible.
Modulation destination “Osc Noise Vol“.
¦ Color
-64 to +63: Adjusts the noise frequency range. Negative values are darker, positive ones are brighter. A value
of 0 is standard “white noise”.
Modulation destination “Osc Noise Color“.
Ring Modulator
The Ring Modulator creates additional frequencies (the sum and difference) by multiplying the oscillator1
and 2 signals. It cannot be active in Split Mode.
Value Meaning
Hold Polyphonic. Notes are held until they are all released and a new note is played.
¦ Osc Volume
-64 to -63: Determines the total level of all oscillators and input signals (but not Noise or Ring Modulator) im-
mediately before entering the lters. Note: The value 0 is unity gain i.e. already maximum volume - positive
values control Saturation intensity only.
Modulation destination “OscVolume“.
¦ Portamento
Off, 1 to 127: Determines how slowly the pitch of notes glides from one to the next. The actual effect of por-
tamento depends on the KeyMode.
Modulation destination “Portamento”.
¦ Punch
>0 to 127: Enhances the percussive effect of short Attack times in the amplier envelope. At higher values,
Punch becomes a noticeable “snap” at the start of each note.
Modulation destination “Punch Intensity”.
¦ FiltEnv>Sync Frequency
-64 to +63: Controls how much lter envelope is applied to. Only visible if at least one of the oscillators is in
HyperSaw mode.
Sync Offset. Analogous to FiltEnv>FM in the other oscillator models. If oscillators 1 and 2 are both Hyper-
Saws, this parameter modulates the Sync Offset of both oscillators at the same time. Note that it will not
effect oscillator1 if SYNC is not active.
Modulation destination “FiltEnv>FM/Sync”.
¦ Sync Frequency
0 to 127: The frequency offset of the audible HyperSaw with
Only visible if at least one oscillator is in HyperSaw mode. Directly accessible from the panel via FM Amount.
respect to its own internal “master” oscillator. Modulation destination “Osc2 FM Amount”.