Specifications
PARAMETER REFERENCE MANUAL46
ENVELOPES
Hardwareinterface: The parameters for Envelopes 3 and 4 can be found in the Single EDIT menu. Press
EDIT, then PARAMETER < > to scroll through to the relevant pages.
Virus Control: To edit envelopes 3 and 4, click the FILTER tab. On the bottom left hand side of the FILTER
page, you will see the Filter Envelope pane. Down the left side of this pane, there are now three buttons
labelled “F” “3” and “4”. Click “F” to view and edit the Filter envelope Click “3” to view and edit Envelope 3.
Click “4” to view and edit Envelope 4.
¦ Decay
0 to 127: The time it takes to fall from maximum to the Sustain level (see below).
¦ Sustain
0 to 127: The nominal level after the Decay.
¦ Sustain Slope
-64 to +63: Negative values cause the sustain phase to decay to zero, positive values cause it to rise to
maximum.
¦ Release
0 to 127: The time it takes to fall from the current level to zero after the note is released.
Accessible from the panel via the amp RELEASE knob.
Envelopes 3 and 4
Two additional envelopes are now available as modulation sources in the mod matrix. They behave in exactly
the same way as the lter and amplier envelopes, with the same ve stages:
¦ Attack
How quickly the envelope reaches its maximum state
¦ Decay
How long it takes to fall from the peak of the attack phase to the sustain level
¦ Sustain
The level at which the envelope stays so long as you hold the note
¦ Sustain Slope
Positive values cause the sustain level to rise towards maximum. Negative values cause it to fall towards
minimum. The more extreme the value, the faster it will rise or fall.
¦ Release
How long it takes for the envelope to fall to its minimum state once the key is released.