Specifications

PARAMETER REFERENCE MANUAL54
MODULATOR PARAMETERS
¦ Key Follow
Off, 1 to 127: How much LFO1 rate is affected by MIDI note number. Note that Key Follow does not apply
when LFOs are in Envelope Mode or are synchronized to the Clock).
LFO 2
All edit parameters for LFO2 are the same as those for LFO1.
LFO 3
The edit parameters for LFO3 are the same as those for LFO1, except that Contour, Envelope Mode and
Trigger Phase are not available in LFO3.
LFO 1 Destinations
¦ Osc1 Pitch
-64 to +63: How much LFO1 modulates oscillator1 pitch.
Modulation destination “LFO1>Osc1Pitch“.
¦ Osc1+2 Pitch
-64 to +63: How much LFO1 modulates the pitch of all oscillators, controlling the other two values in this
page at the same time.
¦ Osc2 Pitch
-64 to +63: How much LFO1 modulates oscillator2 pitch. Note that oscillator 3 automatically follows any
pitch modulation applied to oscillator2.
Modulation destination “LFO1>Osc2Pitch“.
¦ Pulse Width
-64 to +63: How much LFO1 modulates the pulse width of both main oscillators.
Modulation destination “LFO1>PulseWidth”.
SHAPE Negative Positive
Sine to Triangle to Square
Triangle to falling Saw to rising Saw
Saw concavity convexity
Square pulse width <50% pulse width >50%
S&H --- ---
S&G --- ---
3 to 64 zoom into wave ---
¦ Mode
Mode Meaning
Poly Each voice has its own LFO, and these are slightly detuned against each other.
Mono All voices share a common LFO. Only applies if the parameters Envelope Mode and Trigger Phase
(see below) are both set to “Off”.
¦ Envelope Mode
Value Meaning
Off Standard (cyclic) LFO mode.
On The LFO effectively becomes an additional Envelope. LFOs in Envelope Mode are unipolar and stop
after completing exactly one cycle. The start/nish point within the wave can be specied via Trigger
Phase...
¦ Trigger Phase
Off, 1 to 127: When set to Off, LFO1 runs freely i.e. its phase is not reset by every note played (except in En-
velope Mode). All other values set the starting point within the wave.