User guide

3- Reconnecting
a. The BlueSync MC remembers up to 8 paired devices. When reconnecting you will
not have to go through the initial pairing set up.
b. To reconnect, make sure that your mobile device is within at least 3 feet of
the receiver and press the (3) Bluetooth pairing button to toggle through the
remembered devices. Allow 3 seconds after pressing the (3) Bluetooth pairing
button each time.
c. If your device does not automatically reconnect by toggling, access the Bluetooth
settings in your mobile device and select “BlueSync MC”.
d. After a successful connection has been made, you will hear a short tone. If your
device does not connect after toggling, please refer to the “Pairing your mobile
Bluetooth device to the BlueSync MC” instructions above.
Playing music:
1- Make sure that your Bluetooth A2DP (audio/music) mobile device is paired with the
BlueSync MC.
2- Simply begin playing music on your mobile device and you should hear the music
play through the BlueSync MC. If the music is low, increase the volume on the
BlueSync MC  rst, then adjust your device’s volume.
3- You can control the volume and playback directly from the BlueSync MC using the
(1) Play/Pause button and (2) Volume +/- button.
4- If you would like to connect a device which does not have Bluetooth capability,
you may use the (6) AUX line-in port on the BlueSync MC. Just use the included (C)
3.5mm audio cable. Connect one end to the headphone jack of your music playing
device, and the other end into the (6) AUX line-in port on the rear of the BlueSync
MC. Once connected, begin playing music on your mobile device and you should
hear the music play through the BlueSync MC.
Pause/Resume
1- Short press on the (1) Play/Pause button to pause the BlueSync MC.
2- Long press on the (1) Play/Pause button to resume the BlueSync MC.
Operating Instructions continued