Specifications

VE106 Groove-N-Go Tool 15
NOTE: A quarter-turn either way will change
the groove diameter adjustment by approxi-
mately 0.013 inch (0,3 mm) or 0.051 inch (1,3
mm) per full turn.
12. Prepare another trial groove, and check
the groove diameter (“C” dimension), as
described in step 10. Repeat these steps, as
necessary, until the groove diameter is within
specification.
GROOVING OPERATION
1. Before grooving, make sure all instruc-
tions in the previous sections of this manual
have been followed.
2. Plug the safety foot switch into an inter-
nally grounded electrical source. Make sure
the safety foot switch and drive motor are
grounded.
DANGER
• To reduce the risk of electric
shock, check the electrical
source for proper grounding.
• Before operating the tool,
review the"Operator Safety
Instructions" section on page 2
of this manual.
Failure to follow these instructions could result in
death or serious personal injury.
CAUTION
• This tool must be used ONLY for roll grooving pipe/
tubing designated in the “Tool Rating and Roll
Selection” section of this manual.
Failure to follow this instruction could overload the
tool, resulting in reduced tool life and/or damage to
the tool.
TM-VE106 3736 Rev_B.fm Page 15 Monday, May 9, 2005 12:02 PM