Instructions / Assembly

3
1.Remove
the existing
3.Route the light control’s
wires through
the large gasket holes.
4.Twist the junction box wires and
wires
together
as
shown.
Secure
with
wire
connectors.
White
to
White
Black to
Black
Junction box ground wire to
green ground screw on
xture.
Gasket
Mounting
Strap
Mounting
Bolt
Rubber
Plug
Install the Light
1.Align the light
control
cover
plate
and
plate
gasket. Secure with
the mounting bolt.
3 To
avoid water damage
and
electrical
shock,
keep
heads
holders
below horizontal.
4.Adjust the heads by loosening the lock
nuts but do not rotate the heads more than
180°from the factory setting.When screwing
in the heads,do not overtighten.
2.If a
wet
lo
cation
junction
box
was not
used,
caulk
the wall plate mounting surface
with silicone
sealant.
Wire the Light Control
WARNING: Turn power off at circuit breaker
or fuse.
fixture.
fixture
light
2.Install the mounting strap as shown using
two screws that fit your junction box.
cover
Lock Nut
Because this luminaire is equipped with
a photocell, if you make the installation
during the day
, the luminaire will not be
turned ON until dusk.
You may test the unit
the le
v
el of light. When the luminaire in-home
switch is ON, the photocell will automatically
turn the
light on a
t dusk, and off at dawn.If
OFF in the evening,
ou can o
verride the photocell by using the
in-house ON/OFF switch.
The photocell can be affected by light from
car headlights,
str
ee
t lights and other
by covering the photocell with black tape.
However, we do suggest FINALIZING the true
testing at night.
This luminaire includes a photocell,located
o
n the top part
you want to turn the light
y
luminaires,
which may cause it to turn O F F prematurely.
The luminaire should be located where other
light sources will not affect the
photocell.
Dusk to Dawn Operation
Photocell
THIS PHOTOCELL
MUST BE FACING UP
5.please note: the photocell must be
facing up.
of the canopy, which senses