Operation Manual

English

Installation

Warning Indicator

 When the “LAMP” indicator lights solid red, the projector

will automatically shut itself down. Please contact your local

reseller or service center.

 When the “TEMP” indicator lights solid red, it indicates the

projector has been overheated. The projector will automati-

cally shut itself down.

Under normal conditions, the projector can be switched on

again after it has cooled down. If the problem persists, you

should contact your local dealer or our service center.

 When the “LAMP” indicator ﬂ ashes red, it indicates the fan

failed. Please contact your local dealer or our service center.

Powering Off the Projector

1. Press the “Power/Standby” button to turn off the projector

lamp, you will see a message “

” displayed on the projector’s screen. Press the “Power/

Standby” button again to conﬁ rm, otherwise the message

will disappear after 5 seconds.

Please note that if the key is pressed instead, the projec-

tor will enter the “Picture Mute” mode and no image will

be displayed. To exit the “Picture Mute” mode, press the

“Power/Standby” button again.

2. The cooling fans continue to operate for about 10 seconds

for cooling cycle and the Power LED will turn green. When

the Power LED begins ﬂ ashing, the projector has entered

standby mode.

If you wish to turn the projector back on, you must wait

until the projector has completed the cooling cycle and has

entered standby mode. Once in standby mode, simply press

“Power/Standby” button to restart the projector.

3. Disconnect the power cord from the electrical outlet and the

projector.

4. Do not turn on the projector immediately following a power

off procedure.