User's Manual

System Configuration
6-86
6
• HTTP Server: Shows if management access via HTTP is enabled.
• HTTP Server Port: Shows the TCP port used by the HTTP interface.
• Version: Shows the version number for the runtime code.
AP Wireless Configuration – The AP Wireless Configuration tables display the radio
and VAP interface settings listed below. Note that Interface Wireless A refers to the
802.11a radio and Interface Wireless G refers the 802.11b/g radio.
• SSID: The service set identifier for the VAP interface.
• Radio Channel: The radio channel through which the access point communicates
with wireless clients.
• Encryption: The key size used for data encryption.
• Authentication Type: Shows the type of authentication used.
• 802.1X: Shows if IEEE 802.1X access control for wireless clients is enabled.
CLI Commands for Displaying System Settings – To view the current access point
system settings, use the show system command from the Exec mode. To view the
current radio interface settings, use the show interface wireless a 0 or show
interface wireless g 0 command (see page 7-109).
Enterprise AP#show system 7-23
System Information
==========================================================
Serial Number : A123456789
System Up time : 0 days, 4 hours, 33 minutes, 29 seconds
System Name : SMC
System Location :
System Contact :
System Country Code : US - UNITED STATES
MAC Address : 00-30-F1-F0-9A-9C
IP Address : 192.168.1.1
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
VLAN State : DISABLED
Management VLAN ID(AP): 1
IAPP State : ENABLED
DHCP Client : ENABLED
HTTP Server : ENABLED
HTTP Server Port : 80
HTTPS Server : ENABLED
HTTPS Server Port : 443
Slot Status : Dual band(a/g)
Boot Rom Version : v3.0.7
Software Version : v4.3.2.2
SSH Server : ENABLED
SSH Server Port : 22
Telnet Server : ENABLED
WEB Redirect : DISABLED
DHCP Relay : DISABLED
==========================================================
Enterprise AP#