User's Manual
Table Of Contents
- About This Guide
- Introducing the Access Point
- Hardware Installation
- Running the Setup Wizard
- Access Point Configuration
- Client Bridge Mode Configuration
- Troubleshooting
- Using Discovery
- IP Addressing
- Technical Specifications
- Safety Information
- End User Software License Agreement
- Glossary
- Index
- Regulatory Notices for the Wireless 11g Access Point
2
HARDWARE INSTALLATION
Introduction This chapter will guide you through a basic installation of the Access
Point, including:
■ Connecting the Access Point to your network.
■ Setting up your computers for networking with the Access Point.
Safety Information
WARNING: Please read the “Safety Information”
section in Appendix D
before you start.
VORSICHT: Bitte lesen Sie den Abschnitt “Wichtige Sicherheitshinweise”
sorgfältig durch, bevor Sie das Gerät einschalten.
AVERTISSEMENT: Veuillez lire attentivement la section “Consignes
importantes de sécurité” avant de mettre en route.
Positioning the
Access Point
You should place the Access Point in a location that:
■ allows convenient connection to the computer or other ethernet
device that will be connected to the LAN port on the rear panel.
■ allows easy viewing of the front panel LED indicator lights, and access
to the rear panel connectors, if necessary.
■ is centrally located to the wireless computers that will connect to the
Access Point. A suitable location might be on top of a high shelf or
similar furniture to optimize wireless connections to computers in
both horizontal and vertical directions, allowing wider coverage.