User's Manual
Table Of Contents
- About This Guide
- Introducing the Access Point
- Hardware Installation
- Running the Setup Wizard
- Access Point Configuration
- Client Bridge Mode Configuration
- Troubleshooting
- Using Discovery
- IP Addressing
- Technical Specifications
- Safety Information
- End User Software License Agreement
- Glossary
- Index
- Regulatory Notices for the Wireless 11g Access Point
Powering Up the Access Point 19
Powering Up the
Access Point
To power up the Access Point:
1 Plug the power adapter into the power adapter socket located on the
back panel of the Access Point.
2 Plug the power adapter into a standard electrical wall socket.
Connecting the
Access Point
The first step for installing your Access Point is to physically connect it to a
switch or hub. See Figure 4
.
Figure 4 Connecting the Access Point
To use your Access Point to connect to the wireless LAN to the wired LAN:
1 Insert one end of the supplied Ethernet (RJ-45 Category 5) cable into the
LAN port on the rear panel of the Access Point.
2 Insert the other end of the cable into the RJ-45 port on switch or hub.
Check that the LAN status LED lights on the Access Point.
You have now completed the hardware installation of your Access Point.
Next you need to set up your computers so that they connect to the
Access Point.
OfficeConnect
Wireless Access Point
Hub / Switch
Wireless
users
Off
iceConnect 11Mbps Wireless Access
Point
3
C
R
W
E
4
1
1
9
6
L
A
N
S
t
a
t
u
s
W
LAN
A
l
e
r
t