User's Manual
Table Of Contents
- About This Guide
- Introducing the Access Point
- Hardware Installation
- Running the Setup Wizard
- Access Point Configuration
- Client Bridge Mode Configuration
- Troubleshooting
- Using Discovery
- IP Addressing
- Technical Specifications
- Safety Information
- End User Software License Agreement
- Glossary
- Index
- Regulatory Notices for the Wireless 11g Access Point
34 CHAPTER 4: ACCESS POINT CONFIGURATION
The password is case sensitive.
If you have forgotten your password you need to reset the Access Point.
See “
Forgotten Password and Reset to Factory Defaults” on page 66
Wizard Figure 21 Wizard Screen
Click WIZARD... to launch the configuration wizard. Refer to Chapter 3
for information on how to run the wizard.
LAN Settings The LAN Settings menu provides the following options:
Unit Configuration The LAN Settings screen is used to determine how the LAN IP address of
your Access Point is obtained. It can be obtained automatically or you can
manually configure the IP address and optionally configure the DHCP
server.