User's Manual
Table Of Contents
- About This Guide
- Introducing the Access Point
- Hardware Installation
- Running the Setup Wizard
- Access Point Configuration
- Client Bridge Mode Configuration
- Troubleshooting
- Using Discovery
- IP Addressing
- Technical Specifications
- Safety Information
- End User Software License Agreement
- Glossary
- Index
- Regulatory Notices for the Wireless 11g Access Point
LAN Settings 35
Figure 22 Unit Configuration Screen
Dynamic IP Address
3Com recommends that you manually assign your Access Point a static IP
address.
Select Dynamic IP Address (automatically allocated) and the screen shown
in Figure 22
is displayed. Check all your settings and click Apply.
If the Access Point is set to obtain an IP address automatically and is
unable to contact a DHCP server then it will allocate itself an address in
the 169.254.xxx.xxx range.