User's Manual
Table Of Contents
- About This Guide
- Introducing the Access Point
- Hardware Installation
- Running the Setup Wizard
- Access Point Configuration
- Client Bridge Mode Configuration
- Troubleshooting
- Using Discovery
- IP Addressing
- Technical Specifications
- Safety Information
- End User Software License Agreement
- Glossary
- Index
- Regulatory Notices for the Wireless 11g Access Point
36 CHAPTER 4: ACCESS POINT CONFIGURATION
Manually setting the IP address
3Com recommends that you assign your Access Point a static IP address.
1 Select Unit Configuration and then select Static IP Address (to be
specified manually). The screen shown in Figure 23
is displayed.
Figure 23 Unit Configuration Screen For Static IP Address
2 Enter the Access Point IP Address and Subnet Mask in the LAN Settings
field. The default static IP address of the Access Point is 192.168.1.1.
3 If you want to use the Access Point as a DHCP Server, click in the Enable
check box. See “
DHCP Server” for more information about configuring
the DHCP server.
4 Check all of your settings, and then click Apply.
DHCP Server
The DHCP server will give out addresses to both wired and wireless
clients.
Before enabling the DHCP Server, ensure that there are no other DHCP
servers running on your network.