User's Manual

LAN Settings 37
If you want the Access Point to function as a DHCP server on your
network, carry out the following:
1 Select Unit Configuration and then select Static IP Address (to be
specified manually). The screen shown in Figure 23
is displayed.
2 Enter the IP address details as described in “
Manually setting the IP
address” and click Enable against The Access Point acts as a DHCP Server.
The screen shown in Figure 24
is displayed.
Figure 24 DHCP Server Configuration Screen
3 Clicking Auto Range automatically selects the largest range of addresses
available for your network. Alternatively you can manually enter Start and
End addresses for the IP address pool. The DHCP server supports up to a
maximum of 253 addresses.
4 Enter any Default Gateway and DNS (Domain Name Server) addresses if
required.
5 Check your settings and click Apply.