User's Manual
Table Of Contents
- About This Guide
- Introducing the Access Point
- Hardware Installation
- Running the Setup Wizard
- Access Point Configuration
- Client Bridge Mode Configuration
- Troubleshooting
- Using Discovery
- IP Addressing
- Technical Specifications
- Safety Information
- End User Software License Agreement
- Glossary
- Index
- Regulatory Notices for the Wireless 11g Access Point
58 CHAPTER 5: CLIENT BRIDGE MODE CONFIGURATION
Configuring Client
Bridge Mode
Once the Access Point has been switched into Client Bridge mode, you
can configure it using the configuration Wizard or by setting options
manually.
To configure the Access Point using the configuration wizard:
1 Click the Welcome menu, followed by the Wizard tab.
2 Click the WIZARD... button and follow the instructions provide on-screen.
To configure the Access Point manually see the sections in the rest of this
chapter.
Welcome Menu Figure 39 Access Point Welcome Screen
The Welcome section allows you to view the Notice board and to change
your Password. You can also gain access to the Configuration Wizard.
The Welcome screens are the same under Access Point mode and Client
Bridge mode:
■ See “Notice Board” on page 33 for details of the Notice Board screen.
■ See “Password” on page 33 for details of the Password screen.
■ See “Wizard” on page 34 for details of the Wizard screen.
The configuration wizard will display options relevant to configuring
Client Bridge mode and will therefore differ from those shown in
Chapter 3
.