User's Manual
Table Of Contents
- About This Guide
- Introducing the Access Point
- Hardware Installation
- Running the Setup Wizard
- Access Point Configuration
- Client Bridge Mode Configuration
- Troubleshooting
- Using Discovery
- IP Addressing
- Technical Specifications
- Safety Information
- End User Software License Agreement
- Glossary
- Index
- Regulatory Notices for the Wireless 11g Access Point
LAN Settings 59
LAN Settings The LAN Settings screen allows you to set the IP Address and Subnet
Mask of your Access Point.
Figure 40 Unit Configuration Screen
To change the LAN settings for your Access Point:
1 Select Unit Configuration. The screen shown in Figure 40
is displayed.
2 Enter an IP Address and Subnet Mask in the LAN Settings field. The
default static IP address of the Access Point is 192.168.1.1.
You must set a static IP address for your Access Point when in Client
Bridge mode. Client Bridge mode does not support DHCP. The Access
Point must be allocated a free address within your wireless network’s
subnet to function correctly.
3 Check all of your settings, and then click Apply.
Wireless Settings The Wireless Settings menu allows to enter the details of the wireless
network to which you are connecting. These can be obtained from your
network administrator.