User's Manual Part 1

Installing the Wireless Barricade
6
On the rear panel, the Wireless Barricade provides:
• Three RJ-45 ports for connection to a 10BASE-T/
100BASE-TX Ethernet Local Area Network (LAN). These
ports can auto- negotiate the operating speed to 10/100 Mbps,
the mode to half/full duplex, and the pin signals to MDI/MDI-X
(i.e., allowing these ports to be connected to any network
device with straight-through cable).
• These RJ-45 ports can be connected directly to a PC or to a
server equipped with an Ethernet network interface card, or to
a networking device such as an Ethernet hub or switch.
• One RJ-45 port for connection to an xDSL or Cable modem.
This is a 10/100 Mbps, full duplex port, Use a Category 3 or
higher cable to connect this WAN port to a xDSL or Cable
modem.
• One RS-232 serial port to connect to an ISDN Terminal
Adapter (TA) or to a PSTN analog modem.
• One parallel printer port that can be connected to a printer.
This printer can then be shared by any LAN/WLAN users.
• Two external antennas (dipole, omni-directional).