Installation manual

Fast EtherHub-8se User’s Guide
3-4 Configuring the Network
Figure 3.3 Cabling Limits for Multiple Hub Configuration
Notes:
1. The maximum length for each cable must be determined by calculations for the
longest path (i.e., node-to-node connection) that passes through that segment.
2. To control the number of hubs in a path, we recommend that one hub be used to
connect to several other hubs. Make sure there is only one path between any two
stations on the network.
3. If you need to connect network devices over a long distance, use a switch or bridge
to split the network up into two or more collision domains. For detailed information
on purchasing the required equipment, contact your local distributor or Accton
representative for support.