User's Manual

–
18
–



Chapter 1 | Introduction
SetupWizard


■
GuestNetworkSetup—Setthenameandpasswordfortheguestwireless 
network.ThiscreatesasecondSSIDforguestusers,limitingtheiraccess 
onlytotheInternet.

◆ AdvancedSetup—NetworkingmodesforAPBridge,APRouter,ormanual 
configuration.

Figure5: AdvancedSetup 



■
APBridgeMode—ConfiguresaninterfaceasattachedtotheWAN(thatis, 
theInternet).Inthefollowingfigure,EthernetPort0andEthernetPort1are
bothattachedtotheWAN.Trafficfromtheseinterfacesisdirectlybridged

intotheInternet.(ThisisalsocalledbridgetoInternet.)

Figure6:BridgetoInternet 



■
APRouterMode—ConfiguresaninterfaceasamemberoftheLAN.Inthe 
followingfigure,EthernetPort1,WirelessLAN0(5GHzRadio),andWireless 
LAN1(2.4GHzRadio)areallincludedintheLAN.Trafficfromthese 
interfacesisroutedacrosstheaccesspointthroughEthernetPort0tothe
Internet.(ThisisalsocalledroutetoInternet.)


Note: Single‐bandaccesspointsonlysupportoneWLAN. 

