User's Manual

–
32
–



Chapter3 | NetworkSettings 
Ethernet Settings


Figure23:EthernetSettings–NetworkBehavior 



Thefollowingitemsaredisplayedon thispage: 

◆ NetworkBehavior —FortheEthernetportwhichisnotprovidingInternet 
access,oneofthefollowingconnectionmethodsmustbespecified. 
(Default:RoutetoInternet)

■
BridgetoInternet —Configuresaninterf acetobeattachedtotheWAN. 
TrafficfromthisinterfaceisdirectlybridgedintotheInternet.(SeeFigure6, 
“BridgetoInternet",onpage17.)IfanEthernetportisbridgedtothe 
Internet,managementaccesscannotbemadebyadirectconnectionto 
thisport.However, ifanotherEthernetpor t orradiointerfaceiswithinthe 
LAN(routedtotheInternet)theaccesspointcanbemanagedthroughthis 
interfacebyaPCwhichisconfiguredwithIPaddressinthesamesubnet. 

■
RoutetoInternet —ConfiguresaninterfacetobeamemberoftheLAN . 
Trafficfromthisinterfaceisroutedacrosstheaccesspointandoutthrough 
aninterfacewhichisbridgedtotheInternet.(SeeFigure7,“Routeto 
Internet",onpage18.)Bydefault,EthernetPort1isroutedtoInternet, 
allowingmanagementaccessviaadirectconnectiontoaPCconfigured 
withanaddressinthesamesubnet. 

■
NetworkName —Thenetworktoberouted.Thedefaultis“Default 
localnetwork”asdisplayedunderLANSettings–LocalNetworks. 

■
AddtoGuestNetwork —Thisportcanonlyaccesstheguestnetwork. 

■
HotspotControlled —Thisport canonlyaccesshotspotservices. 

■
ConfigureHotspot —OpenstheHotspotSettingspage. 