User's Manual

Microsoft Wireless Home Networking USB Adapter or PC Card Adapter 19
Networking software, or if you do not wish to use the
Microsoft Wireless Home Networking software to install the
adapter, you can install the adapter drivers through the
Windows Plug and Play dialogs.
After you connect the adapter to a USB port on your
computer, the New Hardware, Add New Hardware, or
Found New Hardware Wizard (depending on operating
system) appears. Follow the instructions below to install
the adapter driver.
To set up an adapter through Windows Plug and Play on a
Windows XP computer
1. Click the notification icon for Found New Hardware
Device to start the New Hardware Wizard.
2. In the New Hardware Wizard, choose Install from a List
or Specific Location, and click Next.
3. Either choose Search for the best driver and check
Search removable media; or choose Include this
location in the search, and browse to the location of
your CD-ROM drive.
4. Insert the Microsoft Wireless Home Networking setup
CD in your CD-ROM drive, and click Next.
5. After the New Hardware Wizard has located and
loaded your adapter driver, click Finish to exit the
wizard.
To set up an adapter through Windows Plug and Play on a
Windows 2000 computer
1. The Found New Hardware Wizard appears. Click Next.
2. Check Search for a suitable driver for my device, and
select CD-ROM drive.
3. Insert the Microsoft Wireless Home Networking setup
CD in your CD-ROM drive, and click Next.
4. After the Found New Hardware Wizard has located
and loaded your adapter driver, click Finish to exit the
wizard.
To set up an adapter through Windows Plug and Play on a
Windows 98 computer
1. The Add New Hardware Wizard appears. Click Next.