User's Manual

Driver Installation
11
6. The Adapter Setup dialog box will appear. Configure the card as described below,
and click “OK.”
I/O Base - Default: 240 (Check for available resources under Windows NT
Diagnostics.)
IRQ Level - Default: 9 (Check for available resources under Windows NT
Diagnostics.)
Mode - Set to “802.11 AdHoc” or “Infrastructure,” depending on the type of network
you want to connect to (see page 13).
SS ID - A service set consists of all the stations in a wireless network. ( See “Network
Configuration and Planning” on page 13.) All of these stations should have their
SSID set to the same value to identify stations within this network. (Default: ANY)
DS Channel - If you are setting up an Ad-hoc wireless LAN (see page 13), set the
channel number to the same radio channel as that used by the other wireless clients
in your group. However, if you are connecting to a network via an Access Station,
then the channel will be automatically set to that used by the Access Station. (Access
Station default: 11)
RTS Threshold - Set the RTS threshold to the same as that used by the other
devices in your network. (For details see page 8) (Default: Disabled)
Power Saving - You may enable the “PowerSaveMode” for reducing power loading.
(Default: 2432; that is Disabled)