(FCCID : HEDACCWN5301)) W N5301 PC Card Quick Start Guide Published July 2001
Copyright © 2001. All rights reserved. No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without the written permission of Accton Technology Corp.. Accton reserves the right to update and otherwise change the content of this document without being obligated to provide notification of revision.
Quick Start Guide This Quick Start Guide is intended for users familiar with PC Card and driver installation for Windows 98, Windows ME, and Windows 2000. Refer to "Installing the Documentation" on page four of this Quick Start Guide for information on setting up the online documentation. Installation for Windows 98, ME, and Windows 2000 Before installing the driver, you will need a copy of the operating system installation media, usually a CD supplied with your computer or operating system.
6. Enter the name of the Wireless LAN Service Area of the wireless network to which your computer will connect. The name you enter here must be identical to the name assigned to the access point. Capitalization, characters, and spacing must match exactly. i NOTE: If the access point you wish to associate with is set for encryption, you must also enable encryption on the wireless client. Click Advanced to go to screens where you can enable and configure encryption.
Adapter LEDs The WLAN adapter LEDs (Figure 2) perform identical functions when indicating the operational status of the card. Off No access point associated with the card. Slow Blinking Card attempting to associate with an access point. Fast Blinking Card exchanged data with an access point. The higher the data rate, the faster the blinking. Removing the PC Card 1. Use the release lever or button your card slot to free the PC Card (Figure 3). 2. Pull on the sides of the card to remove it from the slot.
Regulatory Compliance Information Radio Frequency Interference Requirements This device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range. FCC requires this product to be used indoors for the frequency range 5.15 to 5.25 GHz to reduce the potential for harmful interference to co-channel Mobile Satellite systems. High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands.
